APP Cold Light Strip Car Interior Decoration with 20m RF Remote Control

Standard factory interior lighting can feel limited when you want to personalise your car's cabin, especially during night driving or long journeys. These cold light decorative strips address that need with a straightforward remote control system that works reliably from a distance. The RF wireless radio frequency remote provides a 20-metre range, letting you adjust colours without taking your eyes off the road or fumbling with wires. Suitable for a wide range of general vehicle models, the kit uses a 1.5W RGB light source inside an aluminium housing for steady performance. The soft rubber light pipe is 6 metres long, giving you enough length to run along dashboards, footwells, or door trims. Available in one-for-four, one-for-five, or one-for-six configurations, it offers flexibility for different interior layouts.

Features and Construction

The light strip is built around a practical aluminium heat sink and a flexible rubber pipe. The electrical design runs on standard 12V car power with a low 0.3A current draw, making it easy to integrate into most vehicles.

Material and Build

The light source uses an aluminium housing for structural support and heat management, which helps maintain consistent light output during extended use. The pipe itself is made from soft rubber, allowing you to bend and route it along curved surfaces without kinking. The overall assembly is rated at 3.5W power consumption, keeping electrical load minimal.

Size and Practical Fit

The basic package includes a 6-metre light pipe, which provides enough coverage for most car interiors including dashboards, centre consoles, and footwell areas. The strip is sold in multiple wiring options – one for four, one for five, and one for six – so you can choose the configuration that matches your vehicle layout. It is listed as a universal fit for general models, meaning no specialised adaptors are required for typical car electrical systems.

Uses and Placement

These lights are intended for interior accent illumination rather than primary driving lighting. The flexible rubber pipe makes them suitable for a variety of installation positions inside the cabin.

Event or Professional Use

For car detailing or customisation shops, the 20-metre remote control range allows technicians to demonstrate colour options to clients from outside the vehicle. The one-for-four, one-for-five, and one-for-six harness options give installers flexibility when wiring multiple zones such as footwells, door pockets, and dashboard strips.

Everyday Home Use

For daily drivers, the lights provide adjustable colour illumination that can be turned on or off with the remote. The 6-metre length is adequate for a single-passenger cabin, and the soft rubber pipe routes neatly under seats or along trim panels. The low 12V voltage and 3.5W power draw make them safe for continuous operation while the car is running.

Benefits and Buying Value

The main advantage of this system is the wireless control combined with a reasonably long strip length. The aluminium housing and standard electrical ratings support steady performance over time.

Reuse and Low Maintenance

The RGB light source is rated at 1.5W and uses an aluminium housing for heat dissipation, which can help extend component life under normal use. The soft rubber pipe is not subject to corrosion, and the RF remote uses standard batteries that are easy to replace. No complex programming is needed for basic colour changes.

Why Choose This Product

If you need a car interior accent light solution with wireless control and multiple wiring options, this kit provides the core components in one package. The 20-metre remote range gives you flexibility to control the lights from anywhere in or near the car. The universal fit means no model-specific adaptors are needed, and the choice of one-for-four, one-for-five, or one-for-six harnesses lets you tailor installation to your vehicle's layout.